Average Reviews:
(More customer reviews)The application for these screen protectors is now and has always been a bit of an art. Your two major enemies are dust and finger grease (clean the screen well!). Your ally is scotch tape and a plan of attack. To get this thing installed right you need to avoid touching the side that adheres to the screen. I do this by rolling little scotch tape rings that I stick to the front of the protector. I use them to hold on to it without touching it. To get the edges lined up more easily, I stick the longest side on first, just the very edge of the protector, no more than a millimeter, and make sure its centered. Sometimes it takes twenty times to get the protector lined up just right, but since you're only sticking the very edge on, it's easy to remove and retry and in the end it is worth the trouble. Once you are satisfied with the way the protector is lined up, slowly SLOWLY proceed to stick the protector to the screen, try to remove any bubbles as they appear. If a bubble is really stubborn, take a close look at it. Can you see a little piece of dust or debris in the center of the bubble? If so, peel back the protector to expose the offending debris and use another tiny roll of tape, sticky side out, to dab the surface of the screen and/or the adhesive side of the protector to remove the dust particle. Then continue to apply the protector. The tape comes off with a slow controlled pull when you're done. That's all there is to it, just be patient and use some tape to remove offending dust and to keep your fingers off the sticky side of the protector. With patience and clever tape use you'll get these covers on and they'll look perfectly bubble free. They don't have any more glare than the screen itself so I don't think that's a big deal, at least they don't make it worse. Good luck, I hope this helped.
P.S. If you you were too hasty during application and have bubbles already, there is hope. You can stick a piece of tape to the corner of the protector and peel the protector away from the screen to where the bubbles are. Use some tape to remove the dust just like I described above. Then just lay the protector back down and remove the tape from the corner. If you touched the adhesive side though, you're out of luck. There is no fix for that. But now you know how to apply the protector correctly.
Click Here to see more reviews about: BoxWave nook ClearTouch Anti-Glare Screen Protector (Single Pack)
The anti-glare and super clear screen protector. ClearTouch Anti-Glare's numerous features enhance your nook's display and provides you with more than protection from scratches!
0 comments:
Post a Comment